What To Know
- Use a small screwdriver or tweezers to turn the tension screw clockwise to increase the tension or counterclockwise to decrease it.
- Use a Phillips #00 screwdriver to tighten the five screws holding the bottom plate in place.
- Yes, you can adjust the DPI settings using the Razer Synapse software or the dedicated DPI buttons on the mouse.
Introduction:
The Razer Naga, with its plethora of programmable buttons, is a gaming mouse that empowers you to conquer virtual worlds. However, when it comes to customizing or repairing your Naga, you may find yourself stumped on how to open it. This comprehensive guide will lead you through the process, ensuring a smooth and hassle-free experience.
Removing the Side Grips
1. Locate the Release Buttons: On the sides of the mouse, you’ll find two small release buttons.
2. Press and Hold: Simultaneously press and hold both release buttons.
3. Slide Off the Grips: Gently slide the side grips away from the mouse body until they detach.
Accessing the Internal Components
1. Unscrew the Bottom Plate: Using a Phillips #00 screwdriver, remove the five screws securing the bottom plate.
2. Lift the Plate: Carefully lift the bottom plate away from the mouse body.
3. Disconnect the Battery: If present, gently unplug the battery connector.
Replacing the Side Buttons
1. Locate the Button Assembly: The side button assembly is located on the inside of each side grip.
2. Remove the Screws: Use a Phillips #00 screwdriver to remove the two screws holding the assembly in place.
3. Replace the Buttons: Remove the old buttons and insert the new ones.
4. Reassemble the Grip: Place the side grip back onto the mouse body and secure it with the screws.
Adjusting the Scroll Wheel Tension
1. Remove the Scroll Wheel Cap: Pull the scroll wheel cap straight up to remove it.
2. Adjust the Tension: Use a small screwdriver or tweezers to turn the tension screw clockwise to increase the tension or counterclockwise to decrease it.
3. Replace the Cap: Push the scroll wheel cap back into place.
Cleaning the Sensor
1. Locate the Sensor: The sensor is located at the bottom of the mouse.
2. Use a Cotton Swab: Dip a cotton swab in isopropyl alcohol and gently clean the sensor lens.
3. Let it Dry: Allow the sensor to dry completely before reassembling the mouse.
Reassembling the Razer Naga
1. Connect the Battery: If applicable, reconnect the battery connector.
2. Place the Bottom Plate: Align the bottom plate with the mouse body and press it down to secure it.
3. Tighten the Screws: Use a Phillips #00 screwdriver to tighten the five screws holding the bottom plate in place.
4. Attach the Side Grips: Slide the side grips back onto the mouse body until they click into place.
Wrapping Up: A Transformed Razer Naga
Congratulations! You have successfully opened and customized your Razer Naga. With its enhanced performance and personalized settings, you’re ready to conquer virtual battlefields like never before.
Frequently Asked Questions
Q1: Why can’t I remove the side grips?
A: Ensure you have pressed and held both release buttons simultaneously. If the grips still don’t detach, gently wiggle them while pressing the buttons.
Q2: Can I change the DPI settings without opening the mouse?
A: Yes, you can adjust the DPI settings using the Razer Synapse software or the dedicated DPI buttons on the mouse.
Q3: How often should I clean the sensor?
A: It’s recommended to clean the sensor every few months, or more frequently if you use your mouse in a dusty environment.
